All India Waterproofing Co.

Established in 1983

Seal Roof
 
 
 
 
 
 
 
 
 
 
 
 
BASEMENT BY "INJECTION & SURFACE" METHOD
 
In case of existing Basement where no access is available for treating the surface from outside and below. We propose to treat the U/G structure by our "Injection & Surface" Method.

The junction of the bottom raft with the vertical wall is to be opened by us and filled with the vertical wall is to be opened by us and filled with metal aggregate of nominal size along with injection (coupling). In the wall area all construction joints are opened to provide Injections. Injections shall be provided as and where found necessary are Bu us as per site conditions. The injections are filled with cement slurry (grouting).

After the injections are finished with cement grouting. We shall provide a layer of I.P.S. of about 2" thick on the floor and the vertical wall is covered with out "Sealroof" water proof layer of about 1" thick like this the structure is waterproofed from inside.

Note: This method is also applicable for Underground tanks. Lift Pits and Overhead water tanks.

 
 
The final surface of the floor will be finished smooth in cement colour and that of the Walls with cement / neeru finish.

If however. It is desired to provide tilling over our treatment then the surface of our treatment will be finished in a manner to receive the tiles. It may please be noted that our treatment should in no manner be punctured or damaged. If any fixtures are necessary, then they will be provided on a protective wall, to be provided over our treatment. So that our treatment is not damaged of tampered with.

In case the floor of the basement is to be subjected to rough and/or heavy use. then a Suitable wearing coat on our surface shall be necessary to be provided by the owners.

In case any existing treatment is present, the same shall be removed by us to expose The surface of R.C.C. Raft.

 
  • R.C.C. Slab.
     
  • R.C.C. Wall.
     
  • R.C.C. junction.
     
  • 25 mm mild steel nozzles.
     
  • 25 mm thick 'SEAL ROOF' cement plaster in Two layers.
     
  • 20 mm thick First layer of 'SEAL ROOF' cement mortar (1:4) with stone aggregate fixed by hand.
     
  • 20 mm thick Second layer of 'SEAL ROOF' cement mortar (1:4) with stone aggregate fixed by hand.
     
  • Top layer 20 mm thick 'SEAL ROOF' cement mortar (1:4) smooth\rough finish.
     
  • 25 MM m.s. nozzles as per site conditions.